The instrument has a pre-programmed microprocessor that controls the assay steps and data processing. Test identification, timing and calibration curve or cut-off value data are in the barcode of each cuvette. Once activated by the cuvette label, the microprocessor controls and guides all assay steps and converts the absorbance values of the samples into concentration units or cut-off values.

Photometer
The QuikRead go photometer consists of a measurement well, three LEDs and light detectors. The photometer has been designed and calibrated both for photometric and turbidimetric measurements.

Touch screen display
The user interface is based on an easy-to-use touch screen display. It is used by touch buttons that appear on the screen. It also provides the user with messages and prompts for performing each assay step, and gives test results and error messages.

• 4-wire resistive
• Display size: 116.16 * 87.12 mm.
• Pixels: 640 * 480

Dimensions & power requirements
• Weight: 1.7 kg without power supply
• Size: 27 x 15.5 x 14.5 cm

• Power requirements:
- 100–240 V AC
- 50–60 Hz power supply or accumulator unit power consumption 8 W
• Power supply: supplied with the instrument
• Accumulator unit: supplied separately, only an accumulator unit supplied for QuikRead go use can be used. (Cat. no. 136205 QuikRead go accumulator unit)

Instrument software
The instrument is ready to use. No software has to be installed prior to use. Software updates can be uploaded with a USB stick. (Cat. no. 137540 Software USB stick for QuikRead go)

Instrument identifier
Each QuikRead go instrument has a unique serial number which can be found on the label on the bottom of the instrument.

Memory
The QuikRead go instrument has an internal memory for results history. The QuikRead go instrument has an internal memory for result history. There is a separate result history for patient samples and for quality control samples. Results can be seen from the display or printed to the QuikRead go printer or send to the USB stick as a .csv type file.

Power supply
The instrument is powered by a power supply supplied with the instrument. In addition to the power supply, the instrument can use an accumulator-unit as a power source. An internal switch inside the cable connector will switch automatically from accumulator-powered use to mains-powered use. QuikRead go Accumulator unit is sold separately (Cat. no. 136205).